Automatic Hot Knife Strip Cutting Machine: Model SC-430 USP

The SC 430uSP is a microprocessor-controlled, fully automatic hot knife strip cutting machine, manufactured in Denmark by K. SUHR A/S. It will measure and cut almost any type of synthetic material, from thin ribbon to heavy webbing, using an electronically heated, pneumatically operated hot knife. An exhaust fan is built into the machine case for exhausting the fumes created by the melting of the materials being cut.

The machine can be operated in either metric (millimeters, mm) or English units (inches), as needed. The machine can measure and cut small or large quantities of materials up to 5.0" wide (125 mm), and in lengths ranging from 0.1" (or 1 mm), to over 100 yards (99.9 m). It will produce consistently accurate lengths and high-quality sealed edges. Frequently used lengths can be stored into the machine's memory for instant recall. Eight standard memory cells are available for this purpose.

The machine is portable and designed for tabletop operation, using a 220VAC single-phase power supply, and clean, dry compressed air.

OPTIONAL ACCESSORIES:
Photocell Attachment: used for precise cutting of printed materials, reading from a registration mark, for example. Custom sensing devices can also be provided.

Auto Marking Device: pneumatically driven device for the automatic placing of marks on the material as it is being cut. Two types of marking devices are available - hot foil and cold ink.

Hole Punching: pneumatically driven device for the automatic punching of holes in the material as it is being cut. Single, multiple, or shaped holes are possible.

Prefeed Device: an auxiliary device for pulling heavy materials, elastics, or in any case where greater precision is needed. (Highly recommended when using an Automatic Marking Device).

Nova Tech International, L.L.C., P.O. Box 35751, Greensboro, NC 27425. Tel: 800 794-6682; Fax: 336 643-8180.