Foam Generating Systems

LESSCO's New TS-1000 & TS-5000 Series Foamers were REDESIGNED from the ground up, based on an ,b>OPEN ARCHITECTURE; This together with the Industries FIRST REMOTE CONTROL/DIAGNOSTICS Creates The Standard in Foam/Froth Generators.

• Based on PC or PLC control for Flexibility & Expandability
  
• Intuitive TOUCH SCREEN Operators Interface, reduces Operator Errors & Training Time - REDUCING YOUR TOTAL COST OF OWNERSHIP.
  
• Utilizing PROFIBus I/O for High Bandwidth Data Aquisition,Control & Expandability
  
• High Capacity Foam Blenders designed to meet your production requirements, Driven via Variable Speed A/C Inverter Drive.
  
• Progressive Cavity Latex Pump Driven via Independent A/C Inverter Drive w/ Flow Controlled Feed Back to the Micro Processor through Mass Flow Meter Controllers.
  
• Mass Air Controller of the latest design, requiring less maintenance
  
• Filtered Forced Air Electronics Enclosure, virtually eliminates component failure due to harsh conditions
  
• Expandable Hardware & Software utilizing WonderWare to enable the control/monitoring/operation of your entire Laminating Range.
  
• LESSCO In-house programmers & trained technicians for INSTANT UPDATES or modifications to the system via Remote Diagnostics to meet your specific requirements

LESSCO Inc., 1810 Lessco Dr., P.O. Box 1971, Dalton, GA 30722-1971. Tel: 706-2780272; Fax: 706-275-6222.