M9000 Digital Cutting System (ETS-M9000)

The Eastman M9000 static table cutting system is capable of marking, cutting, drilling and punching virtually any material at speeds of up to 60 inches per second with accuracy of +/- .015 inches.

To hold the material in place during cutting, the M9000 features a porous plastic cutting surface with a vacuum.

Typically, the M9000 is used for single-ply cutting, but depending on the material, multiple layers may be cut, especially if a thin sheet of polyethylene is utilized on the top of the spread to seal the vacuum.

The M9000 features three tangentially controlled tool holders, which may be fitted with any combination of different sized rotary blades, different angles of straight knife blades, variously shaped notch punches and a wide range of drill diameters. There is also a pen for marking and piece identification and an optional non-contact ink jet printer for faster marking capability.

The fabric may be manually laid onto the cutting surface or spread by the optional Easi-Pull attachment, which automatically pulls material from the end of the table to the exact length required for each cut.

Eastman, 779 Washington Street, Buffalo, NY 14203-2396. Tel: 716-856-2200; Fax: 716-856-1140.